Valve 1-2 & Reverse Boost 4T60E

Valve 1-2 & Reverse Boost 4T60E Valve Long Spring Short Spring Coiled Spring Pin Fits either of 2 locations The continuous stroking of the 1-2 (forward) and reverse servo boost valves wear away at the valve bore, creating excess clearance and reduced apply pressures. This can lead to 1-2 band slippage, delayed engagements, 1-2 shift flares, and decreased reverse pressure. Sonnax has developed an oversized valve 84754-40K that will restore the hydraulic integrity and more than doubles the valve-to-bore contact area to prevent leakage. Symptoms: 1-2 Band burned1-2 Flare Delayed engagement Low Reverse pressure Cause: These complaints may be caused by the continuous reciprocation of the 1-2 (forward) and reverse servo boost valves wearing the valve body bores. Correction: This oversized, hard-coat anodized aluminum valve restores hydraulic integrity, and has increased valve-to-bore contact to prevent leakage. This valve requires the use of a Sonnax reaming tool kit. NOTE: This kit only contains one valve. If both bores need to be repaired, two kits are required. Required tools: Reamerkit 4T60E, 4T65E 1-2/Rev: 84754-TL2