Solenoid reg.valve AODE,4R70W

Solenoid reg.valve AODE,4R70W Valve Spring End Plug O-Rings 1 extra The solenoid regulator valve ensures that the solenoids are not flooded with more pressure than they can exhaust. When the regulator valve sticks, the pressure becomes too high and the unit may exhibit wrong gear starts. A more common problem is wear in the solenoid regulator bore, causing working pressure to be too low. Low solenoid pressure results in no 2nd, no 3rd or a shift to neutral on a 3-4, 4-3 shift. Sonnax solenoid regulator valve kit 76948-14K prevents both sticking and leaking. Sonnax bore sizing tool 76948-BST2 is required to fit this valve to a closer tolerance. Hard-anodized valve has extended spool lengths that provide more sealing area with the bore, preventing sticking and leakage. A new spring is included to correctly regulate the extended spool valve. An O-ringed end plug is included to prevent shift solenoid oil pressure loss at the 1-2/2-3 shift valve. Annular grooves prevent side loading that leads to premature wear and leakage. Required use of the Sonnax bore sizing tool, 76948-BST2, removes the bore ridges that lead to valve stickiness and resizes the bore for optimum fit with the Sonnax valve. Symptoms: 2-3 Neutral 3rd & Reverse only Erratic shifts Loss of Forward under hard acceleration from a stop Neutral after 4th No 2nd Cause: Bore wear causes the valve to stick or reduce solenoid pressure. Correction: The Sonnax solenoid regulator valve has more surface contact to reduce sticking and oil loss, and increases working pressure to the shift solenoids.